IZOMAX IZOPROTECT POLYESTER

General Details

IZOMAX IZOPROTECT POLYESTER is a prefabricated protecting membrane reinforced with polyester or fiberglass with a special multi-layered design for superior pliability, puncture strength and resistance to elements.
IZOMAX IZOPROTECT POLYESTER  is a uniquely formulated protecting membrane specially designed with a superior pliability, tensile strength, and tear resistance to different loads which stands out with its convenience and advantages.
It is designed to protect waterproofing systems that may be on roofs, reservoirs, basements, tunnels and car parks. Due to its superior mechanical properties, it resists sharply angled aggregates from damaging the waterproofing system.

Application Areas

Strength, elasticity and heavy duty reinforcement properties are synonyms with IZOPROTECT bituminous protection membrane maximizes the range of application areas.
It is designed to protect waterproofing systems that may be on roofs, reservoirs, basements, tunnels and car parks. Due to its superior mechanical properties, it resists sharply angled aggregates from damaging the waterproofing system

Advantages
  • Total protection to waterproofing systems
  • Very high resistance to impact and puncture.
  • Outstanding bond ability and seam integrity.
Storage & Preserving
  • Rolls should be installed in an upright position on the delivery vehicle and stored and Carried indoors in the same way.
  • Should not be exposed to ultraviolet rays (UV) and to sudden changes of temperatures
  • Rolls should be covered for protection from UV rays if they are to be stored for a long period of time.
  • No cutting or perforation should be made after the application.
  • It should not be exposed to UV rays after the application without mineral stone cap sheet or protective coating.
  • Rolls should not be put one on top of another if stored without palettes.
Application
  • Installed by torch welding method, loose – laid of fully bonded to substrate. When loose – laid only overlaps are bonded together, Periph – eres and protrusions are sealed according to specifications.
  • 10 cm (4 inches) over topping shall be allowed for joints and 15 cm ( 6 inches ) over topping for ends by using welding torch.
  • Mineral coated products may be used to protect the upper surface if no covering is planned.